This guide explains how to configure replication settings for your system. Replication is essential for ensuring data redundancy, high availability, and load balancing. Below are the key steps and considerations:

1. Basic Configuration

  • Enable Replication: Set replication.enabled = true in the configuration file.
    Replication_Configuration
  • Define Replication Roles:
    • Master: The primary node that handles write operations.
    • Slave: The secondary node that replicates data from the master.
    Master_Slave_Setup

2. Advanced Settings

  • Replication Delay: Adjust replication.delay = 5s to control sync intervals.
  • SSL Encryption: Enable secure communication with replication.ssl = true.
  • Filtering: Use replication.filter = "exclude_sensitive_data" to manage data flow.

3. Verification Steps

  1. Check replication status using SHOW REPLICA STATUS.
  2. Monitor lag via REPLICA_LAG metric.
  3. Validate data consistency across nodes.

For deeper insights into replication architecture, visit our Replication Overview documentation.

💡 Tip: Always test configurations in a staging environment before production deployment.

Replication_Verification

If you need further assistance, refer to Troubleshooting Replication.